Service Manual

CHASSIS

3-20 Toro Z Master G3 3000/5000/6000 Series Service Manual

Park Brake Handle Installation (2012 &

Later)

2. Install the clevis ends of the right and left brake

cables to the parking brake handle assembly using

two clevis pins and cotter pins (Fig. 072).

1. Install the left and right brake cables in the slots in

the bottom of the brake pivot assembly and install

the e-rings (Fig. 071).

Fig. 071 DSCN-2627a

Fig. 072 DSCN-2635a

3. Install two screws through the park brake handle,

two spacers, and tighten the assembly to the frame

(Fig. 073).

Fig. 073 DSCN-2637a

4. Plug the wire harness to the park brake switch.

5. Install the two screws retaining the right hand

motion-control cover assembly to the frame and

tighten (Fig. 074).

Fig. 074 DSCN-2614a

6. Operate the park brake handle to make sure

everything is moving freely.