Service Manual

MOWER DECKS

6-25Toro Z Master G3 3000/5000/6000 Series Service Manual

12. If the front deck links do not have enough adjust-

ment to achieve accurate cut height, the single point

adjustment can be utilized to gain more adjustment.

13. To adjust the single point system, loosen the two

bolts at the bottom of the height-of-cut plate (Fig.

458).

14. If the deck is too low, tighten the single point adjust-

ment bolt by rotating it clockwise. If the deck is too

high, loosen the single point adjustment bolt by

rotating it counterclockwise (Fig. 459).

Note: Loosen or tighten the single point adjustment

bolt enough to move the height-of-cut plate

mounting bolts at least 1/3 the length of the

available travel in their slots. This will regain

some up and down adjustment on each of the

four deck links.

Fig. 458 g. 96 G017029

Fig. 459 g. 97 G017036

A. Bolts at the bottom of the height-of-cut plate

A. Single point adjustment bolt