Operator's Manual

seatbecauseofthejumperwirebeingused.Run
theengineatfullthrottleandreleasethebrake.
6.Runthemachineatleast5minuteswiththe
motion-controlleversatfullforwardspeedtobringthe
hydraulicoiluptooperatingtemperature.
Note:Themotion-controlleverneedstobeinneutral
whilemakinganynecessaryadjustments.
7.Bringthemotion-controlleversintotheneutral
position.
8.Adjustthepumpcontrolrodlengthsbyrotatingthe
doublenutsontherodintheappropriatedirection
untilthewheelsslightlycreepinreverse(Figure79).
g027428
Figure79
1.Doublenuts
9.Movethemotion-controlleverstothereverseposition,
andwhileapplyingslightpressuretothelever,allow
thereverseindicatorspringstobringtheleversback
toneutral.
Note:Thewheelsmuststopturningorslightlycreep
inreverse.
10.Shutoffthemachine.Removethejumperwirefrom
wireharnessandplugtheconnectorintotheseat
switch.
11.Removethejackstands.
12.Raisethedeckandinstalltheheight-of-cutpin.
13.Checkthatthemachinedoesnotcreepinneutralwith
theparkbrakesdisengaged.
AdjustingtheMotion-Control
Damper
Thetopdamper-mountingboltcanbeadjustedtoobtaina
moredesiredmotion-controlleverresistance.SeeFigure80
formountingoptions.
Figure80
Right-handmotioncontrolshown
1.Torquethelocknutto23N-m(17ft-lb).Theboltmust
protrudepasttheendofthelocknutaftertorquing.
2.Mostresistance(rmestfeel)
3.Damper
4.Mediumresistance(mediumfeel)
5.Leastresistance(softestfeel)
54