Service Manual

ELECTRICAL
7-3Toro Z Master G3 3000/5000/6000 Series Service Manual
7
PTOSwitch
Purpose
Testing
The PTO (Power Take Off) switch is typically used to
activate the Electric PTO Clutch and to function as part
of the safety interlock system.
HowItWorks
Contacts inside the switch electrically connect various
terminals in both “On” and “Off” position. When the
PTO is pulled out to the ON position, current ows to
the electric clutch and it engages. When the switch is
pushed in to OFF position, current ows through the
PTO switch to the Park Brake switch as part of the circuit
used to ensure safe starting.
1. Disengage the PTO, set the parking brake, and turn
the ignition to OFF and remove the key.
2. Remove the 4 screws holding the control panel to
the fuel tank.
3. Disconnect the wiring harness from the PTO switch.
4. Press in the locking tabs, on each side of the switch,
and pull the switch out of the control panel.
5. Verify that there is continuity between the appro-
priate terminals in the ON and OFF positions (Fig.
488).
Cont.
OFF (IN) ON (OUT)
not used
Cont.
Open
Open
Cont.
Cont.
Open
Open
not used
Y
Y
Y
Y
N
N
N
N
Fig.488 PTO switch test
Location
The PTO Switch is located on the control panel on the
right fender (Fig. 487).
Fig.487 DSCN-0142a