Service Manual

HYDRAULIC SYSTEM

5-32 Toro Z Master G3 3000/5000/6000 Series Service Manual

19. Disengage the parking brake. Rotate the drive wheel

release handle to the released position. Turn the

wheel hub by hand in both directions relative to the

caliper; no drag of the caliper pad on the wheel hub

is desired.

20. After adjusting the brake, cycle the brake handle a

minimum of six times to allow the cable to seat into

the sheath and mounting tabs. Recheck the spring

length.

21. Rotate the drive wheel release handle to the

operating position.

Fig. 369 DSCN-4315a

22. Installing the wheel Hub slotted nut

• Style A (black nish): (Fig. 370)

Torque the slotted nut to 211 - 260 ft-lbs. (286 - 352 Nm).

Note: Do Not use anti-seize on wheel hub.

Fig. 370 g. 67 G011815_A

A. Style A (black nish) B. 0.03” (0.76mm)

• Style B (yellow zinc): (Fig. 371)

C. Style B (yellow zinc) B. 0.24” (6mm)

Fig. 371 g. 67 G011815_B

18. Hold the end of the threaded rod with a tool and

adjust the lock nut until the spring length is between

1-1/2” and 1-9/16” (3.8 and 4.0cm) (Fig. 369).

Note: DO NOT allow the cable to turn when the nut

is being turned.

Wheel Hub Slotted Nut Installation