Service Manual

CHASSIS
3-39Toro Z Master G3 3000/5000/6000 Series Service Manual
3
9. Install the L-bracket, spring, washer, and nut on the
threaded end of the brake cable (Fig. 142).
Fig. 142 DSCN-4336a
10. Install the L-Bracket with brake pin, washer, and
e-ring to the brake caliper (Fig. 143).
Fig. 143 DSCN-4314a
Fig. 144 g. 79 G016879
11. Engage the parking brake. Measure the overall
length of the compression spring (Fig. 144). The
correct length should be between 1-1/2” and 1-9/16”
(3.8 and 4.9cm). If the spring length is within this
range, no adjustment is needed. If it is not, proceed.
(Left Hand brake shown above)
A. Cable anchor E. Caliper
B. Hold threaded rod here F. Compression spring
C. Measure G. Threaded rod
D. Lock nut H. Hub
A
A
F
B C D
E
E
FG
H
H