Service Manual

CHASSIS

3-18 Toro Z Master G3 3000/5000/6000 Series Service Manual

7. Install the throttle cable under the throttle clamp.

Install the throttle Z-bend in the middle hole on the

throttle arm assembly (Fig. 064).

Fig. 064 DSCN-4279a

Park Brake Handle Assembly

Replacement (2012 & Later)

Park Brake Handle Removal (2012 & Later)

1. Remove the two screws retaining the right hand

motion control cover assembly to the frame and

remove the cover (Fig. 066).

Fig. 066 DSCN-2614a

2. Unplug the wire harness from the park brake switch

(Fig. 067).

Fig. 067 DSCN-2617a

9. Move the throttle control back and forth checking the

operation of the throttle arm assembly.

10. Connect the negative battery cable to the battery.

8. Move the throttle arm assembly to the low idle

position and tighten the throttle cable clamp (Fig.

065).

Fig. 065 DSCN-4281a