Service Manual

MOWER DECK
6-7
Toro TITAN 2009-2013 Service Manual
6
5. Using a spring tool, (Toro part no. 92-5771), remove
the idler spring from the deck post to remove tension
on the idler pulley (Fig. 099).
9. Using a spring tool, (Toro part no. 92-5771), install
the idler spring over the deck post and placing ten-
sion on the idler pulley and mower belt (Fig. 099).
10. Ensure that the belt is properly seated in all pulleys.
11. Install the belt covers (Fig. 100).
Fig. 099 g. 68 G009806
A. Spring tool D. Idler/Tensioner arm
B. Idler/Tensioner spring E. PTO belt
C. Deck spring post
Fig. 100 g. 69 G015790
A. Position the belt cover, ensure the tabs seat
B. Pivot the belt cover down
C. Tighten the screws
A
B
C
E
D
A
C
B
6. Lower the mower to the lowest height-of-cut. Place
the height-of-cut pin in the lock position for lowest
height-of-cut.
7. Remove the belt from the spindle pulleys and PTO
clutch.
8. Install the new belt around the spindle pulleys and
the PTO clutch pulley under the engine (Fig. 099).
WARNING
The spring is under tension when installed and can
cause personal injury.
Be careful when removing the belt.
! !