Service Manual

ENGINE

4-6

Toro TITAN 2009-2013 Service Manual

Fig. 055 PICT-2056

4. Install the fuel and vent lines to the engine.

5. Install the throttle and choke cables to carburetor

linkage.

6. Apply Loctite

242 to the (4) engine mounting bolts.

7. By hand, install the (4) engine mounting bolts.

Note: Some of the engine mounting bolts also

secure the clutch stop bracket and stiffener

tube to the frame. See the exploded views for

application and mounting location.

8. In a cross pattern, torque the (4) engine mounting

bolts to specication - 33 ft-lbs. (44 Nm).

9. Install mufer and new mufer gaskets, if necessary,

to the engine and torque mufer fasteners to

specication - 13 ft-lbs. (17.5 Nm).

10. Install heat shield to the mufer mounting screws

and torque to specication - 5 ft-lbs. (7 Nm).

11. Install the heat shield and mufer to frame mounting

screws and torque to specication - 17 ft-lbs. (23

Nm).

12. Apply anti-seize to the engine crankshaft and the

ends of the drive pulley shaft.

13. Install the drive pulley onto the crankshaft and hold

in position.

Note: The drive pulley is marked “CLUTCH SIDE”

for proper installation (Fig. 056).

Engine Installation

1. Position the engine onto the frame.

2. Connect the battery ground wires (E) to the engine

block, and connect the positive battery wire (F) to

the engine starter motor.

3. Connect the chassis to engine harness connector

(D) (Fig. 055).

Fig. 056 PICT-2044

14. Install the drive belt around the drive pulley.

15. Install the drive belt tensioner spring as oriented

below (Fig. 057).

Fig. 057 PICT-2041