Operator's Manual

AdjustingtheHeight-of-CutPin
Theheight-of-cutisadjustedfrom25to140mm(1to
5-1/2inches)in6mm(1/4inch)incrementsbyrelocating
theclevispinintodifferentholelocations.
1.Movethetransportlocktothelockposition.
2.Pushonthedeckliftpedalwithyourfootandraisethe
mowerdecktothetransportposition(alsothe140mm
(5-1/2inch)cuttingheightposition)(
Figure26).
3.Toadjust,rotatethepin90degreesandremovethepin
fromtheheight-of-cutbracket(Figure26).
4.Selectaholeintheheight-of-cutbracketcorresponding
totheheight-of-cutdesiredand,insertthepin(Figure
26).
5.Pushonthedecklift,pullbackonthetransportlock,
andslowlylowerthemowerdeck.
1
3
2
G017027
Figure26
1.Deckliftpedal
3.Transportlock
2.Cutofheightpin
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itisrecommended
toadjusttheheightoftheanti-scalprollers.
1.Disengagethebladecontrolswitch(PTO),movethe
motioncontrolleverstotheneutrallockedposition
andsettheparkingbrake.
2.Stoptheengine,removethekey,andwaitforallmoving
partstostopbeforeleavingtheoperatingposition.
Figure27
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
Figure28
1.Anti-scalproller3.FlangeNut
2.Bushing4.Bolt
Figure29
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
24