Service Manual

HY13-1512-006-M1/USA
Torqmotor™ Service Procedure
TC, TS, TB, TE, TJ, TF, TG, TH and TL Series
Parker Hannifi n Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 US
50
Assemble second
stator half
7. Assemble the second stator half (8D) over the
two alignment studs and rotor (8A) with seal ring
side down onto the fi rst stator half (8B) aligning
any timing marks applied for this purpose.
CAUTION CAUTION: If the stator half (8B) is a different
height (thickness) than stator half (8D) the
stator vanes (8C) or (8E) of the same length
(height) as the stator half must be reas-
sembled in their respective stator half for the
rotor set to function properly.
Assemble vanes
8. Assemble six vanes (8E), or as many vanes that
will readily assemble into the stator vane pock-
ets.
Assemble full
complement
of vanes
9. Grasp the output end of coupling shaft (12)
with locking pliers or other appropriate turn-
ing device and rotate coupling shaft, drive link
and rotor to seat the rotor and the assembled
vanes (8E) into stator (8D), creating the neces-
sary clearance to assemble the seventh or full
complement of seven vanes. Assemble the
seven vanes using minimum force.
Go to Torqmotor™ assembly procedure #15, to
continue Torqmotor™ assembly.
Rotor Set Component Assembly