Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Caster Assembly and Bearing Replacement
- Caster Wheel Bearing Replacement
- Left Console Replacement
- Right Console Replacement
- Seat Replacement (zx Models Only)
- Seat and MyRIDE™ Platform Replacement (MR Models Only)
- Fuel Tank Replacement
- Throttle Control Assembly Replacement
- Choke Control Assembly Replacement
- Park Brake Handle Assembly Replacement
- Motion Control Assembly Replacement
- Chapter 6 : Hydrostatic Drive System
- Chapter 7 : Mower Deck
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
MotionControlAssemblyRemoval(continued)
g321539
Figure53
MotionControlAssemblyInstallation
1.Positionthemotioncontrolassemblyinplacewiththelinkageextending
towardthetransmission.
2.Securethemotioncontrolassemblytotheframe.
3.Connectthemotioncontrollinkagetothemotioncontrolassembly.
4.Connectthemotioncontroldampertothemotioncontrolassembly.
5.Connectthemotioncontrolhandletothemotioncontrolassemblyusing
thetwobolts.
6.Adjusttheneutralsetting.NeutralAdjustment(page6–4)
7.Connectthebatterybyinstallingthepositivecablerst,thenthenegative
cabletothebattery.
8.Lowertheunitandverifyproperfunction.
9.Adjustthetrackingifnecessary.TrackingAdjustment(page6–5)
AdjusttheMotionControlHandle
Note:Ensureproperadjustmentofneutralandtrackingsettingsbeforeadjusting
themotioncontrolhandles.
1.ParkthemachineonalevelsurfaceanddisengagethePTO.Stopthe
engine,waitforallmovingpartstostop,andremovekey.
2.Disconnectthebatterybyremovingthenegativecablerst,thenthepositive
cablefromthebattery.
3.Movetheleversintotheoperatingposition.
4.Loosenthe2boltsthatsecurethemotioncontrolhandlestothemotion
controlassembly.
5.Aligntheleversfronttobackandsecurethebolts.
TitanServiceManual
Page5–27
Chassis:ServiceandRepairs
3438-774RevA