Service Manual

10 ZT-2800
®
/ZT-3100
®
/ZT-3200
TM
/ZT-3400
®
FILTER AND FILTER GUARD
RefertoFigure4
Disassembly
       

       
-
      



NOTE: Alwaysreplacethelterwhenperform-
ing any internal maintenance to the
transaxle.
 


Inspection
 -

Assembly
 

 
       

 


NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
Figure 4, Filter and Guard
Whenrellingthetransaxlewithoil,
removetheportplug(5),ifinstalled,
andplug(11).Filluntiltheoilreachesthe
lowerlipofport(11)onsidecover.
23
106
105
111
5
11
Unitswillhaveinstalled,thetting
(111)ortheplug(5).
Breatherventonunitsequippedwith
internalexpansiontank.