Service Manual

4-5
Table of Contents
Control Plate
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
CONTROL PLATE (THROTTLE AND CHOKE)
Adjustments
Choke Cable (Figure 4)
1. Move the control lever to full choke and hold.
2. Loosen the clamp.
3. Pull the conduit to the right to remove the slack in the cable.
4. Tighten the clamp on the control plate.
5. Verify proper operation of choke.
NOTE: During start-up, the cable may not stay in the full choke position unless the operator holds it.
NOTE: Choke must be fully closed for maximum fuel pump output.
Figure 4