Service Manual

HYDROSTATIC DRIVE SYSTEM
5-7
Toro TITAN 2014 Service Manual
5
11. Inspecttheidlerarm/tensionerpivotandpulley
bearings for excessive wear and replace if
necessary (Fig. 066).
Hydrostatic Drive Belt Installation
1. Properly route the belt around the (2) hydro input
pulleys,and(2)tensioner/idlerpulleys(Fig.067).
2. Install the drive pulley onto the crankshaft and hold
in position.
Note: The drive pulley is marked “CLUTCH SIDE”
for proper installation (Fig. 068).
C. Washer E. Spacer
D. Friction washer - F. 30 ft-lbs. (40 Nm)
 composite G. Arm
Fig. 066 PICT-2042
F
F
E
D
G
F
D
E
C
Fig. 067 PICT-2043
Fig. 068 PICT-2044