Service Manual

22 ZT-2800
®
/ZT-3100™/ZT-3400™
FAN AND PULLEY
NOTE: It is necessary to remove the
transaxlefromthevehiclebeforeperformingthe
repairprocedurespresentedinthissection.To
remove the wheel from the hub, do so by
removing the lug nuts.  Do not remove the
axle/hub nut unless replacing the hub, the
axle seal or removing the axle shaft.
Beforestartinganydisassembly,makecertain
thatyourworkareaisneatandclean.Clean
theexternalpartsofthetransaxle.
Thefollowingproceduresarepresentedinthe
orderrecommendedforacompleteteardown
ofthetransaxle.
Donotdisassembletheunitanyfartherthan
necessarytoaccomplishtherequiredrepairs.
Reassembly is accomplished by performing
the“Assembly”portionsoftheprocedures.If
theunithasbeencompletelydisassembled,a
summaryoftheassemblyprocedures,inthe
orderinwhichtheyshouldoccur,isgivenon
page38.
Figure 15, Fan/Pulley Kit (207) Conguration “A”
RefertoFigure15
Disassembly
FAN AND PULLEY KIT (207) CONFIGURATION “A”
1. Remove the locknut (122), slotted washer
(123), fan (120) and the pulley (121) from
the input shaft.
Inspection
1. Check all components for excessive wear
or damage. Replace if necessary.
2. Inspect input shaft splines for wear or dam-
age.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 21 for the required torque
values.
NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
TRANSAXLE REMOVAL
122
123
120
121