Service Manual

ManualsBrandsToro ManualsRiding EquipmentToro 74855

HYDROSTATIC DRIVE SYSTEM

5-5

Toro TITAN 2014 Service Manual

9. Safely start the engine and run at full RPM.

9. Stroke the control handles in forward and reverse.

Move the control handles into the neutral position

and verify the rear wheels do not rotate forward or

reverse.

Note: A slight amount of reverse creep is

acceptable.

9. Readjust neutral setting if required.

10. Turn engine off.

11. Install the control cover(s) and torque the fastener to

specication–5ft-lbs.(7Nm).

12. Remove the seat switch bypass jumper wire and

reconnect the seat switch harness connection.

13. Safely lower the unit and verify proper drive system

function.

Forward Tracking Adjustment

Note: Always adjust the neutral setting before the

tracking adjustment.

Note: Do not make tracking adjustments on cold

hydrostatic drive systems. Safely warm the

drive system before making adjustments.

If the unit tracks or pulls to the RIGHT:

1. Remove the LH side control cover.

2. Turn the LH adjustment nut 1 full turn CLOCK-

WISE (tightening the nut).

3. Test drive unit and verify tracking.

4. If unit still pulls to the right, repeat steps 2 and 3

until unit tracks straight.

5. Install the LH control cover and torque the

fastenertospecication–5ft-lbs.(7Nm).

If the unit tracks or pulls to the LEFT:

1. Remove the RH side control cover.

2. Turn the RH adjustment nut 1 full turn CLOCK-

WISE (tightening the nut).

3. Test drive unit and verify tracking.

4. If unit still pulls to the right, repeat steps 2 and 3

until unit tracks straight.

5. Install the RH control cover and torque the

fastenertospecication–5ft-lbs.(7Nm)

(Fig. 064) (RH side shown).

Fig. 064 PICT-3038

8. Turn the adjustment nut (B) clockwise or counter-

clock wise until the tire has stopped rotating OR has

only a slight creep in reverse (RH side shown).

Note: If the tire is creeping in forward, turn the

adjustment nut clockwise, (tighten the nut).

If the tire is creeping in reverse, turn the

adjustment nut counterclockwise, (loosen the

nut) (Fig. 063) (RH side shown).

Fig. 063 PICT-3038