Service Manual

HYDROSTATIC DRIVE SYSTEM

5-4

Toro TITAN 2014 Service Manual

Fig. 061 PICT-6486a

Fig. 060 PICT-6459a

Neutral Adjustment

Note: Do not make neutral adjustments on cold

hydrostatic drive systems. Safely warm the

drive system before making adjustments.

1. Safely raise and support unit so rear wheels are off

the ground.

2. Unplug the seat switch and install a jumper wire

across the harness terminals (Fig. 060).

Note: Jumping the seat switch is for testing /

adjustment procedures only.

3. Safely start the engine and run at full RPM.

4. Verify the motion control handles are in the outward

neutral position.

5. Release the parking brake and observe rear tire

movement. If the tire is creeping in either forward or

reverse, a neutral adjustment is required (Fig. 061).

Note: A slight amount of reverse creep is

acceptable.

6. Turn the engine off.

7. Remove the appropriate control cover (A) (Fig. 062).

Fig. 062 PICT-3039