Service Manual

CHASSIS

3-14

Toro TITAN 2014 Service Manual

5. Remove the RH and LH fenders as shown in this

chapter.

6. Safely remove the fuel tank as shown in this chapter.

7. Remove the (2) control covers (D) (Fig. 022).

Fig. 021 PICT-3009

Fig. 022 PICT-2010

Motion Control Box / Seat Pivot

Service (MX shown)

Note: The entire Control Box / Motion Control

assembly does not need to be removed to

service the Actuator Arm assembly. The

Control Box is shown removed from the frame

for clarity and ease of service.

Motion Control Box / Seat Pivot Removal

1. Raise seat, disconnect battery terminals and remove

the battery from the unit.

2. Remove the (2) control handles.

3. Disconnect the seat switch harness connection and

remove seat switch harness from the routing clip on

the Motion Control Box.

4. Disengage the seat stop (A), from the seat support.

Remove the cotter pins (B) and seat pivot rod (C),

then remove the seat assembly from the unit (MX

Shown) (Fig. 021).

8. Make note of wire harness routing. Disconnect the

RH and LH neutral switches and the parking brake

switch. Open the loom routing clip and remove

harness from the Control Box.