Service Manual

CHASSIS

3-24

Toro TITAN 2014 Service Manual

6. Remove all of the clips and washers (E), then

remove the (3) linkage rods from the chassis.

7. Remove the (2) cotter pins (F), (2) washers and (2)

bushings (G) from the brake bell crank (H)

(Fig. 044).

Fig. 042 PICT-3011

5. Remove the brake return spring (C) and the clip and

washer (D) from the brake rod on the hydro

(Fig. 043).

Fig. 043 PICT-3030

Fig. 044 PICT-3018

8. Slide the brake bell crank (H) to one side and

remove the bell crank from the frame.

9. Inspect all linkage rods, pivot points and bushings

for excessive wear, replace if necessary.

Parking Brake & Linkage Service

Parking Brake & Linkage Removal

1. Tilt seat forward, disconnect and remove the battery.

2. Remove the LH control cover to access the parking

brake handle area.

3. Remove the parking brake pin and washer (A).

Remove the parking brake link from the handle stud.

4. Remove fastener (B) that secures the parking brake

handle to the control box assembly. Remove the

handle from the unit (Fig. 042).