Service Manual

MOWER DECK

6-26

Toro TITAN 2009-2013 Service Manual

A. Deck lift arm E. Slot in rear deck hanger

B. Deck hanger bracket

C. Leveling adjust F. Rear deck hanger

locking nut bracket

D. Slot in deck hanger

Fig. 129 g. 63 G010477

Fig. 130 g. 64 G010312

Leveling the Mower Deck

1. Set anti-scalp rollers to top holes or remove

completely for this procedure.

2. Set the height-of-cut lever to the 3 inch (76mm)

position.

3. Place two 2-5/8 inch (6.66 cm) blocks under each

side of the front edge of the deck, but not under

the anti-scalp roller brackets. Place two 2-7/8 inch

(7.30cm) thick blocks under the rear edge of the

cutting deck skirt; one on each side of the cutting

deck (Fig. 129).

4. Loosen the leveling adjust locking nuts (item 3) on

all four corners so that the deck is sitting securely

on all four blocks. Make sure that the deck hangers

are all the way down (at the top of the slot) and the

deck lift foot lever is pushed back against the stop,

then tighten the four leveling adjust locking nuts (Fig.

130).

A BC

E F

A. Wood block, 2-5/8” (6.66cm) thick

B. Wood block, 2-7/8” (7.30cm) thick

C. Front edge

5. Recheck that blocks t just snugly under the deck

skirt. Make sure all attachment bolts are tight.

6. Verify the deck is level by checking the side-to-side

level and front-to-rear blade slope; repeat deck

leveling procedure if necessary.