Service Manual

HYDROSTATIC DRIVE SYSTEM

5-8

Toro TITAN 2009-2013 Service Manual

Hydrostatic Drive Belt Replacement

Hydrostatic Drive Belt Removal

1. Safely raise and support unit so rear wheels are off

the ground.

2. Remove PTO belt tensioner spring (A) from the deck

to relieve PTO belt tension as shown in chapter 6

(Fig. 071).

Fig. 071 PICT-2041

3. Remove PTO belt from PTO clutch.

4. Disconnect the wire harness connection to the PTO

clutch.

5. Remove the PTO clutch bolt and then remove the

clutch from the engine crankshaft.

6. Remove the drive belt tensioner spring (B) (Fig.

071).

7. Remove the belt from around the crankshaft drive

pulley then remove the drive pulley from the engine

crankshaft. Make note of pulley orientation for

assembly.

8. Disengage the drive belt from the tensioner pulley

and idler pulley.

9. Remove the belt from around both hydro input

pulleys. Do not bend or damage the hydro cooling

fans while walking the belt upward off the input

pulleys.

10. Remove the belt from the unit and inspect. Replace

if necessary.

11. Inspect the idler arm / tensioner pivot and pulley

bearings for excessive wear and replace if

necessary (Fig. 072).

C. Washer E. Spacer

D. Friction washer - F. 30 ft-lbs. (40 Nm)

composite G. Arm

Fig. 072 PICT-2042