Service Manual
HYDROSTATIC DRIVE SYSTEM
5-14
Toro TITAN 2009-2013 Service Manual
5
8. Install the parking brake return spring (A).
9. Install the brake rod into the hydro arm and insert
the retaining pin (B).
10. Install the hydro bypass rod, washer and retaining
clip (C).
11. Install the hydro control rod nut and bolt (D) and
torque to specication - 17 ft-lbs. (23 Nm) (Fig. 091).
Fig. 089 PICT-2043
7. Install and orient the drive belt tensioner spring as
shown (Fig. 090).
Fig. 090 PICT-2041
6. Install the hydro drive belt and verify proper routing
(Fig. 089).
Fig. 091 PICT-2046
D
B
C
A
12. Install the rear wheels and torque lug nuts to
specication – 80 ft-lbs. (108 Nm).
13. Connect battery terminals.
14. Safely lower unit.
15. Add 20w50 engine oil or Toro HYPR-OIL
®
500 to the
hydro reservoir FULL COLD mark.
16. Perform the purging procedure as shown in this
chapter.
17. Perform the neutral and tracking adjustment
procedures as shown in this chapter.
18. Verify proper unit oil levels and function.