Service Manual

CHASSIS
3-19
Toro TITAN 2009-2013 Service Manual
3
Deck Lift Service
Deck Lift Removal
Note: Exploded view shown on next page, 3-20.
1. Remove the PTO belt tensioner spring, then remove
the PTO belt from the PTO clutch as shown in
chapter 6, page 6-5 - 6-8.
2. Remove the deck from the frame as shown in
Chapter 6, page 6-9 - 6-12.
3. Remove the deck lift foot petal center bolt, nut, and
spacer (A).
4. Remove the HOC lever pivot fastener and spacer
(B).
5. Remove the rear HOC arm fastener (C).
6. Remove the HOC plate and foot lift assembly from
the chassis.
7. 54 and 60 Inch Units Only - Remove the front lift pan
(D), spring, and mounting fasteners.
8. Support under the front foot lift pivot rod (E).Remove
the (4) fasteners (F) that retain the pivot bushings.
Remove the pivot rod from the frame. Inspect the (2)
bushings for wear and replace if necessary.
9. Support under the rear pivot rod (G). Remove the
(4) fasteners (H) that retain the pivot bushings.
Remove the pivot rod from the frame. Inspect the (2)
bushings for wear and replace if necessary.
10. Inspect the front lift pan (D), the front pivot rod
(E), the rear pivot rod (G) and all wear / pivot area
for excessive wear, bends and cracks. Replace if
necessary.
Deck Lift Installation
1. Install the front and rear pivot rods (E and G) into the
frame slots and support in position.
2. Install the (4) pivot bushings, (4) gusset plates and
(8) fasteners that secure the pivot rods to the frame.
Torque the (8) fasteners to specication – 5 ft-lbs. (7
Nm) (Fig. 040).
3. 54 and 60 Inch Units Only - Install the front lift pan
(D) and spring to the frame and torque fasteners to
specication - 50 ft-lbs. (69 Nm).
4. Install the rear HOC arm fastener (C). Do not tighten
at this time.
5. Install the HOC lever pivot fastener and spacer (B).
Do not tighten at this time.
6. Install the deck lift foot petal center bolt, nut, and
spacer (A).
7. Torque fasteners A, B and C to specication - 30 ft-
lbs. (40 Nm).
8. Install and level the deck as shown in Chapter 6.
9. Install and properly route the PTO belt, then install
the PTO belt tensioner spring.
(Fig. 041, next page)
Fig. 040 PICT-2087