Service Manual

CHASSIS

3-3

Toro TITAN 2009-2013 Service Manual

Caster Wheel / Bushing Service –

TITAN ZX Chassis

Caster Wheel / Bushing Disassembly

1. Safely raise and support unit so front wheels are off

the ground.

2. Support under caster wheel and remove the nut /

bolt (A).

3. Remove and inspect wheel spanner (B). Replace if

excessively worn.

4. Using an appropriate punch, remove the (2)

bushings (C) from the wheel hub. Inspect bushings

and replace if excessively worn.

5. Properly clean and inspect the front wheel hub area.

Caster Wheel / Bushing Assembly

1. Lightly lubricate bushings (C) and wheel spanner (B)

with No. 2 general-purpose lithium base grease. Fill

center of wheel hub with grease.

2. Install the (2) bushings (C) into front wheel hub,

making sure they are fully seated.

3. Install wheel spanner (B) into the front wheel

assembly.

4. Install front wheel assembly into the front caster.

5. Install the nut / bolt (A) and torque nut to

specication - 35 ft-lbs. (47 Nm).

6. Lubricate bushings / spanner through grease tting

with No. 2 general-purpose lithium base grease.

7. Safely lower unit and verify proper function.

(Fig. 006)

Fig. 006 PICT-2058