Service Manual

ZT-2800
®
/ZT-3100/ZT-3400™ 33
BRAKE ASSEMBLY (Code 1 or 2) (ZT-2800/ZT-3100)
RefertoFigure28
Disassembly
1. Remove the center section per detail on
page 31.
NOTE: Takenoteoftheorientationofthebrake
cam(101)andthebrakepuck(100).
2. Remove the brake (cam) shaft (101) and
the brake puck (100).
3. Remove the O-rings (10) from the brake
(cam) shaft (101) and discard.
Inspection
1. Inspect all components for unusual wear or
damage.
Assembly
1. Install the new O-rings (10) onto the brake
(cam) shaft (101).
NOTE: ApplyathincoatingofoiltotheO-rings
beforeinstalling.
 To protect the O-rings from possible
damage during installation, apply a
protectivecoveringoverthesplinesof
thebrakecam(e.g.,cellophane,tape,
etc.).
2. Place the brake puck (100) onto the brake
(cam) shaft (101). Install the brake cam kit
(208) in center section.
Figure 28, Brake Cam Kit
Character#7 in the model number code = 1
or2.
Example: ZX-XXXX-1XXX-XXXX
100
101
10
10
Center Section