Service Manual

HYDROSTATIC DRIVE SYSTEM

7-38 2007 - 2008 Titan Z Service Manual

23. Pull the mower deck idler arm toward the rear of the

machine. Route the mower deck belt around the

inside of the spring idler arm pulley and release the

idler arm (Fig. 491).

25. Install the left rear tire and wheel assembly.

26. Position the hydro fan cover. Tighten the two screws

to secure the hydro fan cover to the seat box (Fig.

493).

Note: When installing a new transaxle in the ma-

chine, or if any work was performed internally

on the transaxle including changing the oil,

make sure the system is purged prior to doing

any neutral adjustment. Refer to “Purging

Procedures – Transaxles” on page 7-42.

Note: After any service, where the control linkage

was disturbed or after purging procedures

have been performed, check the neutral

adjustment. If the neutral adjustment needs to

be performed, refer to “Neutral Adjustment”

on page 7-39.

Fig. 491 IMG-0364a

Fig. 493 IMG-0546

24. Check the routing of the mower deck belt. Refer to

the mower deck belt routing decal (Fig. 492).

Fig. 492 IMG-0546

26. Raise the machine and remove the jack stands.

Lower the machine to the ground.

27. Connect the negative battery cable to the battery.

28. Operate the machine to make sure it, and all safety

devices, are working properly.