Setup Instructions

4
InstallingtheMotionControl
Levers
NoPartsRequired
Procedure
1.Removethebottom3/8x1inchboltandspring
discwasherfromthecontrolarmshaft.Loosenthe
upper3/8x1inchboltandspringdiscwasherinthe
controlleversothatthelevercanrotateFigure2.
2.Positiontheleversothebottomholealignswith
holeinthecontrolarmshaft.Installspringdisc
washerandbolt.
3.Repeatonoppositesideofunit.
Note:Therearetwoleverheightoptionsavailable.
Placetheleversinthetoptwoholestoincrease
heightofthelevers,orinthebottomtwoholesto
decreasetheheightofthelevers.
Figure2
1.Bolt
4.Seat
2.Springdiscwasher5.Controlarmshaft
3.Motioncontrollever
4.Aligntheleversfront/rearposition.Withthelevers
intheneutralposition,loosenthehardwareand
adjusttheleversslidingand/ortiltingthelever(s)
forwardorbackwarduntilproperlyalignedand
tightenhardware(Figure3).
Figure3
1.Motioncontrollever2.Hardware
5.Iftheendsofthelevershitagainsteachother,
whileinthedriveposition(leversrotatedinasfaras
possible),makeadjustmentsbymovingthelevers
outwardstotheneutrallockpositionandcarefully
bendingthemoutward.Movethembacktothedrive
positionandcheckforclearance.Repeatifnecessary.
6.Ifthemachineturnsrightorleftwhenhandlesare
pushedforwardtogether,adjustthestoponthe
sideoppositethedirectionofturn(seeFigure4).
Loosenthescrewsthatholdthemotioncontrol
limiterstop.Movethestopbackuntiltheunitdrives
straight.Tightenthescrewstolockthestopinplace.
Readjusthandlesifnecessary.
Figure4
1.Controlarmshaft
3.Adjuststop
2.Limiterstopscrews
3