Service Manual
MOWER DECK
5-22 2007 - 2008 Titan Z Service Manual
5
0HDVXUHIURPWKHWLSRIWKHIURQWEODGHWRWKHÀDW
surface under the mower deck and the tip of the rear
EODGHWRWKHÀDWVXUIDFHXQGHUWKHPRZHUGHFN)LJ
302). If the front blade tip is not 1/16 – 5/16” (1.6 –
7.9mm) lower than the rear blade tip, adjust the front
deck hanger.
10. When the front-to-rear blade slope is correct check
the side-to-side level of the mower again. Refer to
the “Leveling the Mower Deck” on page 5-20.
A. Blades front to rear C. Measure here
B. Outside cutting edges
8. Carefully rotate the blades front-to-rear (Fig. 302).
Fig. 302 Fig 46 G007199
A. Deck lift arm C. Deck hanger
B. Float retaining nut D. Leveling adjust locking nut
7. Loosen the leveling adjust locking nuts on all four
corners so that the deck is sitting securely on all four
blocks. Make sure that the deck hangers are all the
way down (at the top of the slot) and the deck lift foot
lever is pushed back against the stop, then tighten
the four leveling adjust locking nuts (Fig. 301).
Fig. 301 ¿J*
A
B
C
D
A
A
A
B
B
B
C
C
C
C C C