Service Manual

ZT-2800
®
/ZT-3100/ZT-3400™ 17ZT-2800
®
17
ZT-2800/ZT-3100 PARKING BRAKE ASSEMBLY (Code 1 or 2)
RefertoFigure12
Disassembly
1. Mark the position of the cam stop retainer
(104) in relation to the side cover (2).
NOTE: The orientation of the cam stop and
brake-camtooneanotherisveryim-
portant. Indicate their relationship to
eachotheronthesidecovertoassist
in their correct assembly. See Insert
below.
2. Remove the retaining clip (103).
3. Mark the position of the brake (cam) shaft
(101) in relation to the brake handle (102).
4. Remove the brake handle (102).
5. Remove the hex head screws (105) and the
cam stop retainer (104).
Figure 12, Parking Brake
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
2. Inspect the splines on the handle and brake
cam shaft.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 21 for the required torque
values.
NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
Only if character #7 in the model number
code is 1 or 2.
Example: ZX-XXXX-1XXX-XXXX
Cam Stop Retainer (104)
105
102
103
Brake (Cam) Shaft (101)
Side Cover (2)
Brake-Cam
Shaft
(101)
Cam Stop
Retainer
(104)
ORIENTATION