Service Manual

HYDROSTATIC DRIVE SYSTEM
7-132007 - 2008 Titan Z Service Manual
7
Motion Control Pivot Assembly
2. Install the bolts, metal washers, plastic washers,
lever mount post, and nuts to the motion control
pivot (Fig. 399).
1. Tap two new bearings into the motion control pivot
assembly (Fig. 398).
Fig. 398 IMG-0502a
Fig. 399 IMG-0506a
A. Nuts D. Motion Control Pivot
B. Lever Mount Post E. Metal Washers
C. Plastic Washers (4) F. Bolts
A
B
C C
D
E F
3. Tighten the bolts and nuts until you feel resistance
on the lever mount post - Do Not over-tighten (Fig.
400).
4. Install the neutral switch into the motion control pivot
assembly (Fig. 401).
Fig. 400 IMG-0489a
Fig. 401 IMG-0516a