Setup Instructions

ManualsBrandsToro ManualsOutdoorsTimeCutter SW3200 32 in. 452 cc Zero-Turn Riding Mower with Smart Park - CARB

FormNo.3415-319RevA

TimeCutter

SWRidingMowers

ForAllTimeCutter

SWRidingMowers

SetupInstructions

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCalifornia

tocausecancer,birthdefects,orreproductiveharm.

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Connectthebattery.

Rearhitch1

Bolt(5/16x1inch)

Locknut(5/16inch)

Installtherearhitch.

Steeringwheel

Topcover1

Locknut1

Rearcover1

Screws

Installthesteeringwheel.

Shoulderbolt(seatswithoutadetached

cushiononly)

Seat(seatswithoutadetachedcushion

only)

Hexbolt2

Washer2

Seatpan

Seatassembly(seatswithadetached

cushiononly)

Bottomcushion(seatswithadetached

cushiononly)

Flange-hexbolt(seatswithadetached

cushiononly)

Installtheseattotheseatpan(machines

shippedinasteelcrateonly).

Seatassembly

Seatrod

Hairpincotters2

Spacers(certainmodelsonly)

Installtheseatassembly.

Grassdeector(ifnotinstalled)

Installthegrassdeector.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3415-319*A

Summary of content (8 pages)

PAGE 1
Form No. 3415-319 Rev A TimeCutter® SW Riding Mowers For All TimeCutter® SW Riding Mowers Setup Instructions Note: Determine the left and right sides of the machine from the normal operating position. WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Setup Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
Procedure Description Use Qty. 7 No parts required – 1 8 Ignition key Hose coupling (not included with CE models) Operator's Manual Engine Owner’s Manual (non-Toro engines) KeyChoice® key (blue) 1 Check the mower adjustment. 1 1 Complete the setup.
PAGE 3
2 3 Installing the Rear Hitch Installing the Steering Wheel Parts needed for this procedure: 1 Rear hitch 2 Bolt (5/16 x 1 inch) 2 Locknut (5/16 inch) Parts needed for this procedure: Procedure 1. Install the bracket to the frame as shown in Figure 2. 2. Torque the bolts between 19.8 and 25.4 N∙m (175 and 225 in-lb). 1 Steering wheel 1 Top cover 1 Locknut 1 Rear cover 2 Screws Procedure 1. Rotate the steering column up to the user position (Figure 3).
PAGE 4
Installing the Seat to the Seat Pan Machines Shipped in a Steel Crate Only Parts needed for this procedure: g027737 Figure 4 1. Steering-wheel cover 4. Top cover 2. Locknut 3. Steering wheel 5. Column 6. Install the rear cover to the back of the footrest with the tabs at the bottom inside the footrest and the 2 screws in the top (Figure 5).
PAGE 5
B. Place the seat onto the seat pan, aligning the attached seat bolts with the front keyholes, and slide the seat back. 5 C. Secure the seat to the seat pan using 2 hex bolts and 2 washers (Figure 7). Installing the Seat Assembly Parts needed for this procedure: 1 Seat assembly 1 Seat rod 2 Hairpin cotters 2 Spacers (certain models only) Procedure 1. Install the seat assembly to the frame with the seat rod, 2 hairpin cotters, and 2 spacers (certain models only) as shown in Figure 8.
PAGE 6
Installing the Grass Deflector Parts needed for this procedure: 1 Grass deflector (if not installed) Procedure g027695 g027695 If the grass deflector is not installed, remove it from the packaging and install it onto the mower deck. Refer to your Operator’s Manual for the correct procedure to install the grass deflector. Figure 9 3. Route the wire harness to the right side of the machine and push the plastic connector into the seat frame hole (Figure 10).
PAGE 7
8 Completing the Setup Parts needed for this procedure: 1 Ignition key 1 Hose coupling (not included with CE models) 1 Operator's Manual 1 Engine Owner’s Manual (non-Toro engines) 1 KeyChoice® key (blue) Procedure Checking the Tire Pressure Check the front and rear tires for proper inflation; refer to Checking the Tire Pressure in the Operator's Manual for the recommended inflation pressure.
PAGE 8