Service Manual

44 ZT-2100
Figure 8. Motor Shaft
Refer to Figure 8.
Disassembly
1. Remove the control arm and bypass arm.
See page 39.
2. Drain the oil from the transaxle. See page
11.
3. Remove the side cover. See page 42.
4. Remove the reduction gears. See page
43.
5. Remove at washer (70), motor shaft and
pinion gear (73 & 72) and at washer (74).
Note:Itisnotnecessarytoseperatethe
motor shaft (73) and pinion gear (72)
unlesstheyaredamagedandneedre-
placed.
Inspection
1. Inspect the motor shaft (73), pinnion gear
(72) and at washers (70 & 74) for wear or
damage.
Assembly
1. Insert the motor shaft (73) with the pinnion
gear (72) and at washers (70 & 74) into the
center section (20).
2. Install the reduction gears. See page 43.
3. Install the side cover. Refer to page 42.
4. Install new seals. Refer to page 40.
5. Fill the transaxle with oil. See page 11.
6. Install the bypass arm and control arm. See
page 39.
MOTOR SHAFT
74
73
72
71
70
20