Setup Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 74626

FormNo.3382-314RevA

TimeCutter

RidingMower

ModelNo.Allmodels

SetupInstructions

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Connectthebattery.

Rearhitch1

Bolt(5/16x1inch)

Locknut(5/16inch)

Installtherearhitch.

Nopartsrequired

–

Setupthemotion-controllevers.

Nopartsrequired

–

Connecttheseatholdbar.

Nopartsrequired

–

Checkthemoweradjustment.

Ignitionkey1

Hosecoupling(notincludedwithCE

models)

Operator'sManual

EngineOperator'sManual

Operatortrainingmaterial

Completethesetup.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3382-314*A

Summary of content (4 pages)

PAGE 1
Form No. 3382-314 Rev A TimeCutter® Riding Mower Model No. All models Setup Instructions Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Connect the battery. 2 Rear hitch Bolt (5/16 x 1 inch) Locknut (5/16 inch) 1 2 2 Install the rear hitch. No parts required – Set up the motion-control levers. No parts required – Connect the seat hold bar. No parts required – Check the mower adjustment.
PAGE 2
1 2 Connecting the Battery Installing the Rear Hitch No Parts Required Parts needed for this procedure: Procedure 1. Locate the battery and negative battery cable. 1 Rear hitch 2 Bolt (5/16 x 1 inch) 2 Locknut (5/16 inch) 2. Remove the plastic cap from the negative battery post. 3. Remove the fasteners on the negative battery cable, and use them to secure the negative battery cable to the negative battery post (Figure 1).
PAGE 3
4 Setting Up the Motion-control Levers Connecting the Seat Hold Bar No Parts Required No Parts Required Procedure Procedure 1. Locate the seat-hold bar on the frame of the machine. 1. Locate the motion-control levers attached, but folded down on the machine. 2. Remove the fasteners. 2. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch). 4. Secure the bar with the washer and cotter pin removed previously (Figure 4). 3.
PAGE 4
5 6 Checking the Mower Adjustment Completing the Setup Parts needed for this procedure: No Parts Required Procedure Adjust the side-to-side level and the front-to-rear blade slope. Use the relevant procedures in the Operator's Manual to verify that the deck is level, and make any adjustments as necessary. Refer to the Operator's Manual for more information.