Service Manual
CHASSIS
3-20
Toro TimeCutter SS/MX/ZS Service Manual
3
Motion Control Damper Service
Motion Control Damper Removal
1. Remove the fender / pod as shown in this chapter.
If servicing the LH motion control damper, fuel tank
removal is required and the procedure is shown in
this chapter.
2. Remove the (1) shoulder bolt (A) and washer (B)
that secures the upper motion control damper eyelet
to the actuator arm (Fig. 031).
Motion Control Damper Installation
1. Install the washer (B) and upper damper eyelet to
the actuator arm and torque the shoulder bolt (A) to
specication – 7.5 ft-lbs. (10 Nm).
2. Install the lower eyelet to the frame stud (D) and
torque the nut (C) to specication – 7.5 ft-lbs. (10
Nm).
3. Install the fuel tank (if necessary) and the fender /
pod as shown in this chapter.
4. Check the motion control system for proper function.
(Fig. 032)
Fig. 031 PICT-1111
Fig. 032 PICT-1110
3. Remove the (1) nut (C) that secures the lower
motion control damper eyelet to the frame mounting
stud (D).
4. Remove the motion control damper from the unit.
C
B
C
A
D