Service Manual

CHASSIS

3-8

Toro TimeCutter SS/MX/ZS Service Manual

6. Remove the (2) control handles (D).

7. Remove the RH and LH fenders as shown in this

chapter.

8. Remove the fuel tank as shown in this chapter.

9. Disconnect the (2) upper bolts that secure the LH

and RH motion control dampers (E) to the actuator

arms (A).

10. Disconnect and remove the neutral switches as

shown in the Electrical chapter. See “RH and LH

Neutral Switch”, page 7-5.

11. Move the deck HOC to the middle position.

12. Support under the deck in current position, then

move the deck HOC to the lowest position.

13. Remove the (2) fasteners and (2) washers securing

the LH and RH hydro rod pins (F) to the actuator

arms (A).

14. Remove the (6) fasteners securing the control box

assembly (G) to the frame.

15. Remove the control box / motion control assembly

from the frame.

Note: The RH deck lift-lever must pass through

the control box (G) during removal and

installation.

(Fig. 017)

Motion Control / Control Box / Seat

Pivot Service

Note: The entire Control Box / Motion Control

assembly does not need to be removed to

service the Actuator Arm assembly. The

Control Box is shown removed from the

chassis for clarity and ease of service.

Control Box / Seat Pivot Removal

1. Raise seat and disconnect battery terminals.

2. Disconnect the seat switch harness connection and

remove seat switch harness from the routing clip on

the seat base.

3. Remove the washer and retaining clip, then remove

the seat stop assembly (B).

4. Remove the retaining clips and the seat pivot rod /

seat stop rod (C).

5. Remove the seat assembly from the unit (Fig. 016).

Fig. 016 PICT-1043