Service Manual

CHASSIS

3-10

Toro TimeCutter SS/MX/ZS Service Manual

Control Box / Seat Pivot Installation

1. Install the control box / motion control assembly onto

the frame.

Note: The RH deck lift-lever must pass through

the Control Box (G) during removal and

installation.

2. Install the (6) fasteners securing the control

box assembly (G) to the frame and torque to

specication:

• Self-tapping Screws - 14 ft-lbs. (18 Nm)

• Nut / Bolt Fastener - 17 ft-lbs. (23 Nm)

3. Raise deck HOC, support is no longer needed.

4. Install the fasteners (H) and nylon washer (I)

securing the hydro rod pin (F) to the actuator arm

assembly (A). Torque fasteners to specication -

8 ft-lbs. (11 Nm). Be sure the nylon washer (I) is

installed in-between the actuator arm assembly (A)

and the hydro control rod as shown (Fig. 018) (only

LH side shown).

5. Install and connect the neutral switches as shown

in the Electrical chapter. See “RH and LH Neutral

Switch, page 7-5.

6. Install the (2) bolts that secure the LH and RH

motion control dampers (E) to the actuator arms (A)

and torque to specication - 7.5 ft-lbs. (10 Nm).

7. Install the fuel tank and both fenders as shown in

this chapter.

8. Install seat assembly. Properly route and connect

seat switch.

9. Connect battery and lower seat.

10. Install RH and LH control handles (D) and torque the

fasteners to specication - 30 ft-lbs. (40 Nm).

11. Verify proper unit function. Neutral and tracking

adjustments are shown in Chapter 5, see pages 5-3

and 5-4.

(Fig. 019)

Fig. 018 PICT-1046