Service Manual

CHASSIS

3-14

Toro TimeCutter SS/MX/ZS Service Manual

Pod / Fender Support Installation

1. Position the Pod / Fender support bracket onto the

chassis.

2. Install the fasteners (A, B and C) that secure the

support to the chassis and torque to specication –

17 ft-lbs. (23 Nm).

3. Properly route the fuel lines / wire harness and

secure with cable ties (if needed).

4. Install hydro tank reservoir (MX models only).

5. Install and connect hour meter (if equipped).

6. Install fuel tank and fenders.

7. Verify proper cable, wire harness and hose routing.

8. Connect battery terminals and lower seat

9. Verify proper unit function.

Pod / Fender Support Service

Pod / Fender Support Removal (MX Shown)

1. Raise seat and disconnect battery terminals.

2. Remove fenders and fuel tank as shown in this

chapter.

3. Take note of cable and harness routing for

reassembly.

4. Disconnect and remove the hour meter (if equipped).

5. Remove the fasteners (A) attaching the hydro

reservoir to the support bracket (MX models only).

6. Remove the cable ties that secure the fuel lines /

wire harness cables (if equipped).

7. Remove the fasteners (B) securing the (2) rear

supports to the frame.

8. Remove the fasteners (C) securing the front fender

support to the frame.

9. Remove the Pod / Fender support bracket from the

chassis.

(Fig. 025)

Fig. 025 PICT-1060