Service Manual

HY13-1512-006-M1/USA
Torqmotor™ Service Procedure
TC, TS, TB, TE, TJ, TF, TG, TH and TL Series
Parker Hannifi n Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 US
40
Press in dirt &
water seal
3. Press a new dirt and water seal (20) into the
housing (18) outer bearing counterbore.
The Small Frame Series TC, TS, TB and TE
Torqmotor™ dirt and water seal (20) must
be pressed in until its’ fl ange is fl ush against
the housing. SEE FIGURE 40.
The Large Frame Series TF, TL, TG, TJ & TH
Torqmotor™ dirt and water seal (20) must
be pressed in with the lip facing out and
until the seal is fl ush to .020 inches (.51 mm)
below the end of housing. SEE FIGURE 41.
4. Place housing (18) assembly into a soft
jawed vise with the coupling shaft bore
down, clamping against the mounting
fl ange. SEE FIGURE 42.
Place housing
assembly
into vice
Figure 42
Figure 41
Figure 40
Figure 39
Torqmotor™ Assembly