Service Manual

CHASSIS

3-70 Toro GrandStand Service Manual

37. 2010 only: Secure the lower end of the lift bar to

the rear cross shaft assembly using the dampener

assembly and nut. Thread the dampener assembly

bolt into the nut until there are 3 threads protruding

(Fig. 0261).

Fig. 0261 DSCN-0793a

34. 2010 only: Repeat steps 31 through 33 on the other

side of the machine.

35. Install the fuel tank. See “Fuel Tank Assembly Instal-

lation” on page 3-29.

36. 2009 only: Secure the lower end of the lift bar to

the rear cross shaft assembly using a nut. Thread

the nut onto the bolt until there are 3 threads pro-

truding (Fig. 0260).

Fig. 0260 DSCN-0274a

38. Place the HOC pin into the 3” (7.62cm) HOC

position, then verify that the blade height is also at 3”

(7.62cm).

Note: Use the dampener assembly bolt (2009 uses a

nut) to adjust as needed (Fig. 0262).

39. Bleed the hydraulic system. See “Bleeding the

Hydraulic System” on page 6-95.

Fig. 0262 DSCN-0793a

33. 2010 only: Install the bolt until the gap between the

control tower mount and spring cap is 1-1/2” (3.8cm)

for 60” decks / 2” (5cm) 48” or 52” decks (Fig. 0259).

Fig. 0259 DSCN-0820a

A. 1-1/2” (3.8cm) for 60” decks

2” (5cm) for 48” for 52” decks