Service Manual

CHASSIS
3-25Toro GrandStand Service Manual
3
18. Tighten locknut until spring washers are at (15 ft-
lbs./20 Nm) and then back off a 1/4 turn to properly
set the pre-load on the bearings.
19. Remove the plug from the side of the pivot hub (Fig.
0091).
21. Fill the pivot hub cavity until grease is purging out
through the upper bearing (Fig. 0093).
Fig. 0091 DSCN-0436a
20. Install a grease zerk into the port on the side of the
pivot hub (Fig. 0092).
Fig. 0092 DSCN-0434a
Fig. 0093 DSCN-0438a
22. Replace the grease zerk with the plug (Fig. 0094).
Fig. 0094 DSCN-0436a