Service Manual

CONTROLS

4-5Toro GrandStand Service Manual

3. Remove the two screws securing the pivot shaft in-

side the RH motion control lever (Fig. 0644 & 0645).

Note: Only one bolt will typically back out due to

both threading into the same inner rod. A #4

easy-out can be used to secure the pivot rod.

The bolt on the opposite side can then be

removed (Fig. 0646).

Fig. 0644 IMG-0977a

Fig. 0645 IMG-0979a

Fig. 0646 IMG-0980a

4. Remove the RH control lever assembly from the

control tower (Fig. 0647).

Fig. 0647 IMG-0983a