Service Manual

CHASSIS
3-153Toro GrandStand Service Manual
3
45. 2009 only: Secure the assembly using a washer
and nut (Fig. 0577).
Fig. 0577 DSCN-1607a
46. 2009 only: Repeat steps 43 through 45 on the other
side of the unit.
47. 2010 only: Position the RH pivot shaft through the
carrier frame hub and rear cross shaft assembly
(Fig. 0578).
Note: 48” and 52” decks are set to a narrow stance.
Remove the wheels to install the pivot shafts.
Reinstall the wheels after installing the pivot
shafts.
Fig. 0578 DSCN-1392a
48. 2010 only: Rotate the pivot shaft so the spiral pin
hole of the pivot shaft aligns with the spiral pin hole
of the rear cross shaft assembly, then secure the
assembly with the spiral pin (Fig. 0579).
Fig. 0579 DSCN-1395a
Note: The spiral pin ends need to be ush to the lift
arm hub (Fig. 0580).
Fig. 0580 DSCN-1400a