Service Manual

CONTROLS
4-4136” & 40” Toro GrandStand Service Manual
4
19. PulltheRHandLHsliderspacersrearwardasfaras
possible(Fig.333).
Fig. 333 DSCN-3812a
20. Tightentheclampassemblytosecurethecableto
thesliderassembly(Fig.334).
A. Leftcableadjustment B. Rightcableadjustment
Fig. 334 DSCN-3811a
Adjusting the Tracking
Note: Determine the left and right sides of the
machine from the normal operating position.
1. Whiledrivingthemachine,pushbothcontrollevers
forward the same distance.
2. Checkifthemachinetrackstooneside.Ifitdoes,
stopthemachineandsettheparkingbrake.
3. Releasetheoperatorcushionfromtherearofthe
machine.
4. Rotatetherightcableadjustmenttopositionthe
rightmotioncontrolinthecenterofthecontrol
panelneutrallockslot.Then,rotatetheleftcable
adjustment in quarter-turn increments until the
machinetracksstraight(Fig.335).
Note: Only adjust the left cable to match the left
wheel speed to the right wheel speed. Do
not adjust the right wheel speed as this will
position the right motion control lever out of
the center for the control panel neutral lock
slot.
Fig. 335 g.55G012898
A
B