Service Manual

CONTROLS
4-2 36” & 40” Toro GrandStand Service Manual
4
LH Motion Control Lever Installation
5. Remove the bolt and jam nut from the handle
assembly(Fig.187).
1. Installaplasticbearingintoeachendofthecontrol
handle(Fig.189).
Fig. 187 DSCN-3595a
6. Removethetwoplasticbearingsfromtheendsof
thecontrolhandle(Fig.188).
Fig. 188 DSCN-3597a
Fig. 189 DSCN-3597a
2. Loosely install the bolt and jam nut to the handle
assembly(Fig.190).
Note: The nut will be tightened in a later step.
Fig. 190 DSCN-3599a