Service Manual
ELECTRICAL
8-2936” & 40” Toro GrandStand Service Manual
8
30. Install the battery ground wire and the wiring har-
ness ground wire to the engine block (Fig. 813).
Fig. 813 DSCN-2688a
28. Make sure the mufer exhaust is centered in the
mufer guard assembly then tighten all four bolts
and nuts. Torque the nuts to 19 ± 2 ft-lbs. (25.76 ±
2.7 Nm) (Fig. 811).
Fig. 811 DSCN-2680a
29. Connect the clutch wire harness to the wire harness
(Fig. 812).
Fig. 812 DSCN-2686a
31. Install the starter wire to the solenoid using a lock
washer and nut. Torque nut to 35 in-lbs. (4 Nm) (Fig.
814).
Fig. 814 DSCN-2533a