Service Manual

CONTROLS

4-136” & 40” Toro GrandStand Service Manual

LH Motion Control Lever

Replacement

LH Motion Control Lever Removal

1. Removetheshoulderboltandangenutsecuring

the end of the control cable to the LH motion control

lever(Fig.183).

Note: Only one bolt will typically back out due to

both threading into the same inner rod. A #4

easy-out can be used to secure the pivot rod.

The bolt on the opposite side can then be

removed (Fig. 185).

Fig. 183 DSCN-3570

2. Removethetwoboltssecuringthepivotshaftinside

the LH motion control lever. One bolt is located

on the outside of the control tower. The second is

locatedattheoppositeendofthecontrolhandle

(Fig.184).

Fig. 184 DSCN-3573

Fig. 185 DSCN-3584a

3. Remove the LH control lever assembly from the

control tower.

4. Removethepivotrodfromthemotioncontrolhandle

(Fig.186).

Fig. 186 DSCN-3591a