Service Manual

TORO®- Grandstand Service Instruction Manual3-18

CHASIS

Engine Guard Removal (Figure 16)

1. Remove the 2 nuts on the inside of the engine

guard.

2. Remove the 2 nylon washers on the outside holes

of the engine guard.

3. Pull up to remove the engine guard.

Engine Guard Installation

1. Place the engine guard assembly in the space

between the frame rails.

2. Push the engine guard to one side then insert the

nylon washer in the space on opposite side.

3. Place bolt through the hole in the frame, nylon

washer and engine guard. Secure with a nut.

NOTE: Do not over tighten at this time.

4. On the opposite side of the engine guard assembly,

place bolt through hole in frame, engine guard, and

nylon washer. Secure with nut.