Service Manual

6-4
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
LUBRICATION SYSTEM
Maintenance (Cont.)
3. Lower the hose into the drain pan.
4. Drain the oil.
5. Place a drain pan under the oil lter and remove.
6. Remove and discard oil lter gasket if still on the cylinder block.
7. Once oil has drained, install hose into the cleat and slide onto shroud tting.
8. Install the new oil lter.
NOTE: Verify oil lter gasket from step 6 is removed.
9. Tighten lter until the gasket contacts the engine block, continue tightening 3/4 turn or torque 106 in-lbs. (12
Nm).
10. Fill the crankcase with oil, see “Oil Chart,” section 1, page 1-11.