Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Caster Fork and Bearing Replacement
- Caster Wheel Replacement
- Left Console Replacement
- Right Console Replacement
- Seat Replacement
- Fuel Tank Replacement
- ROPS (Roll Over Protection System) Replacement
- Throttle Cable Assembly Replacement
- Choke Control Assembly Replacement
- Park Brake Handle Assembly Replacement
- Adjusting the Park Brake
- Motion Control Damper
- Motion Control Assembly Replacement
- Adjusting the Motion Control Handle Position
- MYRIDE® Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Kawasaki Engine Electrical Schematic
LevelingtheMowerDeck(continued)
6.Measurebetweentheoutsidecuttingedges(bladetips)andtheatsurface.
Ifallmeasurementsarenotwithin5mm(3/16inch),anadjustmentis
requiredandthisprocedureshouldbecontinued.
7.Rotatethebladessothattheyareperpendiculartotherearofthedeck.
Ensurethefrontbladetipislowerthantherearbladetipasindicatedinthe
BlockHeightandRakeT able(step12).
g336158
Figure67
1.BladesFronttoRear
3.MeasurefromtheTipoftheBladetothe
FlatSurface
2.BladeTip
8.Settheanti-scalprollerstothetoppositionorremovecompletelyforthis
procedure.
9.For60inchdeckonly:
•Raisethedecktothetransportposition.
•Slowlyloosentheadjustingscrewontheliftassistspringuntilthescrew
canberemoved.Savethescrewforinstallation.
10.Place2blocks(seeBlockHeightandRaketablestep12)undertherear
edgeofthecuttingdeckskirt,oneoneachsideofthecuttingdeck.
11.Settheheight-of-cutlevertothe76mm(3inch)position.
12.Place2blocksundereachsideofthefrontedgeofthedeck,butnotunder
theanti-scalprollerbracketsorwelds.
Deck:ServiceandRepairs
Page6–10
2000SeriesZMASTER®ServiceManual
3438-778RevA